Roller Hardness Metal Sheet Straightening Machine , HSC 58 - 60 Plate Leveling Machine

1. Wipe the roll surface, make the surface clean, to make sure no foreign body on the rolls;

2. Add appropriate amount lubrication oil into the reducer;

3. Check the machine parts without foreign body and tools;

4. Adjust top roll to make the space between top roll and lower roll greater than the mesh thickness;

5. Starting motor, made the machine dry run a quarter of an hour, then start flattening the mesh, gradually adjusting the two lead screws pressure, to make the mesh level up.

Safety Caution:

1.Set bench board on the side of feeding, must not place metal foreign body and tools on the bench board;

2.When replace the mesh thickness, first adjust the gap between the two rolls greater than the mesh thickness, then gradually adjusting the two lead screws pressure, to make the mesh level up. Must not flattening when the gap is too little, it will result in equipment damage;

3.Pay attention to the personal safety when operating. The distance between two hands and rolls should not less than 300mm;

4. For security, set ground points under the motor, must have reliable ground points when the machine working.